5-in-1 AIO flight controller using OpenVTX (up to 400mW), 12A ESC (BLHeli_S ESC), onboard ELRS receiver (2.0 firmware), plugin connector for your motors and can take 1S or 2S batteries.

Notes: This is the V2 version capable of taking up to 2S.

Specifications:

FC:
Betaflight firmware target: CRAZYBEEF4SX1280
MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
Sensor: ICM42688P
Mount hole size: 25.5mm*25.5mm
Power supply: 1-2S battery input (DC 2.9V-8.7V)
Built-in 12A (each) Blheli_S 4in1 ESC
Built-in Betaflight OSD (SPI Control)
Built-in 5.8G OpenVTX 0mw~400mw
Built-in ExpressLRS 2.4G,
Built-in voltage meter sensor: voltage meter scale 110
Built-in current meter sensor: current meter scale 470
Weight: 5.1g

4in1 ESC:
Power supply: 1-2S LiPo/LiPo HV
Current: 12A continuous peak 15A (3 seconds)
Supports BLHeliSuite
Factory firmware: Z_H_30_REV16_7.HEX
Default protocol: DSHOT300
Supports Bluejay firmware
When using Bluejay firmware with 48khz, set startup power to 1100/1200

Receiver:
Packet rate options: 50Hz/150Hz/250Hz/500Hz
ExpressLRS firmware version: V2.0
RF frequency: 2.4GHz
Antenna : SMD antenna
Telemetry output Power: <12dBm
Receiver protocol: SPI ExpressLRS
Compatible with ExpressLRS V2.0 TX Modules
Can’t flash ExpressLRS firmware separately

OpenVTX:
Firmware version: OPENVTX
Smartaudio v2.1
PIT mode supported
RACE mode supported
Channels: 48ch
Transmitting Power: 0/RACE/25mw/100mw/400mw
Power supply: DC 5V
Current (5v): <650ma (400mw)
Antenna connector: U.FL

Package:
1x X12 AIO Board
1x Dipole UFL Antenna
1x Camera cable
1x PH2.0 Pigtail
1x set of screws and grommets

Wiring diagram here

There are currently no product reviews.

Write Review

There are currently no videos